CBL - Campus del Baix Llobregat

Projecte llegit

Títol: Aerodynamic Analysis and Optimization of a 2026 Formula 1 Active Rear Wing


Estudiants que han llegit aquest projecte:


Director/a: ALTMEYER, SEBASTIÁN ANDREAS

Departament: FIS

Títol: Aerodynamic Analysis and Optimization of a 2026 Formula 1 Active Rear Wing

Data inici oferta: 24-01-2026     Data finalització oferta: 24-09-2026



Estudis d'assignació del projecte:
    GR ENG SIS TELECOMUN
    GR ENG SIST AEROESP
    GR ENG TELEMÀTICA
Tipus: Individual
 
Lloc de realització: EETAC
 
Paraules clau:
Formula 1, rear wing, aerodynamic optimization, aerodynamic efficiency, CFD simulations
 
Descripció del contingut i pla d'activitats:
This project studies the "Active Aerodynamics" in Formula 1 based on the new rules for 2026. The new regulation allows the cars to have active moving parts, which means the wings can move while the car is driving. The project will study how this new rear wing works in its two main positions (Mode X and Mode Z).

The Main Goals are:
- Design a 3-part rear wing that fits the new 2026 FIA rules.
- Mode Z (Corner mode): use Ansys (CFD) to test the wing when it is tilted up. The goal here is to get maximum downforce (grip) so the car can go fast through corners.
- Mode X (Straight line mode): test the wing again when it is flat. The goal here is to get minimum drag (air resistance) so the car reaches a high top speed.
- Compare the results to see how much more efficient the car becomes when it switches between these two modes.
 
Overview (resum en anglès):
Formula 1 is a competition in which car manufacturers fight against each other for the best result on the track. It is a matter of technical development of a vehicle that could provide the best performance in terms of speed and stability. One of the most crucial components of a car in Formula 1 is the rear wing, whose aerodynamic characteristics influence a lot the behavior of the car on the track. From the perspective of the technical design of a car in Formula 1, active aerodynamics is a step forward in terms of adaptability to different regimes. Traditionally, the rear wing in Formula 1 is passive, and it has been more or less the same for decades. An engineering team had to choose between two options - a profile with a high coefficient of lift that would provide a stable grip on the track, but at the expense of a relatively low speed on the straight, and a profile with a low coefficient of lift, but with a high speed on straights and, accordingly, a reduced grip in the turns.
With active aerodynamics, the car will be able to adapt to changes in the regime by itself, which should allow it to demonstrate better efficiency. The project explores the possibility of using an active three-element rear wing in Formula 1. The goal of the project is to research the aerodynamic characteristics of the three-element rear wing using 3D CFD (Computational Fluid Dynamics). For analysis, the standard profiles known as NACA (National Advisory Committee for Aeronautics) were used, based on which certain constructions were selected for study. The analysis covers two modes of operation of the rear wing: X (straight) and Z (turn). In the first case, the wing elements are laid out to form a low profile and, accordingly, achieve a high speed on the straight. In mode Z, the wing elements are turned to a greater angle to maximize the coefficient of lift and, thus, gain additional grip on the turn. The project should give a complete overview of the performance characteristics and efficiency of the active wing in different modes.


© CBLTIC Campus del Baix Llobregat - UPC